HOW TO CHECK A BATTERY
- Night Life Outlawz
- Feb 26, 2022
- 2 min read

A car’s battery should be tested twice a year to minimize the chances of battery failure.
Step 1: Prepare your ride for the battery test.
Turn off your ignition as well as all the lights and other electric or electronic device that may use battery power when the ignition is off. Disconnect the ignition system by uncoupling the ignition coil or taking out the fuel pump fuse or relay.
Step 2: Check for dead battery terminals.
Dead battery terminals are sometimes difficult to spot with a just simple visual inspection; hence, you should use a multimeter
Tip: Hard starts, no-start, and other starting issues are sometimes caused by loose, corroded, or dirty terminals
With the ignition system off, touch the red probe of the multimeter to the positive battery post and the black probe to the cable terminal that connects to the same battery post. Ask someone to crank the engine and take note of the reading.
Do the same for the other battery terminal but this time, the black probe should be the one touching the negative battery post and the meter’s red probe to the cable terminal that connects to the same battery post. If the multimeter registers more than 0.5 volts, check the terminals for damage.
Step 3: Test the battery.
Testing your car’s battery voltage can be done using a voltmeter or a power probe
Tip: Testing a car’s battery using a voltmeter is easy. Just make sure to connect the voltmeter’s lead to the right battery terminals and take note of the voltage reading
How to test a battery with a voltmeter
Take out the battery’s terminal cover and clean the terminals. Set the voltmeter to the lowest voltage setting that’s above 15 volts. Connect the voltmeter’s positive (red) lead to the battery’s positive terminal and touch the voltmeter’s negative (black) lead to the battery’s negative terminal. Check the voltage reading.
How to test a battery with a power probe
Remove the battery’s terminal cover and attach the positive (red) lead of the power probe to the battery’s positive terminal. Connect the negative lead of the power probe to the battery’s negative terminal. Touch the tip of the probe to the battery’s positive terminal and check the voltage reading.
Step 4: Interpret the voltage reading.
A voltage reading of 12.4 up to 12.7 volts means the battery is in good condition. A reading below 12.4 volts means the battery needs to be charged. If the reading is lower than 12.2 volts, you will need to trickle charge the battery and repeat the test.
The battery has excessive voltage if the voltmeter or power probe displays more than 12.9 volts. In this case, you can turn on the car’s high beams to reduce excessive voltage surface charge. You may also have the alternator checked as it’s possible that it is over charging the battery.
QUESTION:
How many volts should a good battery have?
What does the red terminals represent on the battery?
What can you test a battery with?
Name 5 things that use a Battery
1).
2).
3).
4).

コメント